MultiTrack Plus
MultiTrack Plus is a premium quality 100% acrylic emulsion fortified with rubber particles designed for coating asphalt and latex/rubber
running track surfaces. MultiTrack Plus is available in Red or Black. 'Red' MultiTrack Plus contains red EPDM rubber granules and
'Black' MultiTrack Plus contains black EPDM rubber granules. MultiTrack Plus beautifies tracks and provides superior protection against
oxidization, ravelling, and moisture penetration. MultiTrack Plus is available in 30-gallon fiber kegs or 55-gallon steel drums.
2 Colors to choose from: Red and Black
Surface Preparation
New asphalt must cure for 21 days prior to application of coatings. Pavement surface must be cleaned entirely
of dust, dirt, mildew (if any) debris and all loose materials including vegetation. Depressions and shallow, damaged areas in the asphalt
surface can be corrected by patching with MultiLane Acrylic Patch. Cracks can be
filled with MultiFlex Crack Sealant. All repairs must be flush and smooth to adjoining
surfaces. A tack coat of MultiAcrylic Adhesion Promoter is recommended prior to
the initial coat of MultiTrack Plus, particularly on older tracks which are likely to be oxidized.
Coverage
Coverage will normally range from 0.10 to 0.29 gallons per square yard per coat depending on the age,
roughness, and porosity of the surface. Yields are based on undiluted MultiTrack Plus.
Dilution and Mixing Procedure:
Dilute MultiTrack Plus with water using the following ratio:
Mixing Ratio
MultiTrack Plus............................ 10-gallons
Water.......................................... 2.4-gallons to 2.6-gallons (24% - 26%)
Important: The amount of water required will vary according to ambient temperature. Higher
temperatures may require greater water dilution to a maximum of 26% of the undiluted MultiTrack Plus
Application
As a coating, MultiTrack Plus is applied using a soft rubber squeegee. A second
coat would be applied in the same manner as the first coat only after the first coat had thoroughly dried. It is recommended that the coated
surface be allowed to cure for a minimum of 24 hours before opening the running track for use.
Cautions:
- Read the container label before using. Follow label instructions.
- When applying, air temperature must be a minimum of 50 degrees F. (10C) and rising. Do not apply if surface temperature exceeds 135
degrees F. (57C)
- Do not apply when rain is imminent or forecast
- When applying indoors, use with adequate ventilation during application and drying
- Close containers when not in use
- Do not store in direct sunlight or where temperature may exceed 100 degrees F.
- KEEP FROM FREEZING
Important:
- When applying surface coatings during periods of very hot weather, apply coatings at the coolest
part of the day, usually in the early morning. Do not apply if surface temperature is 135 degrees F. (57C) or above. When you encounter
hot weather which the surface temperature exceeds 135 F. (57C), it is best to apply one coat in the early morning before the temperature rises
and then wait until the next morning to apply the next coat.
Drying Time: 45 to 90 minutes under optimum drying conditions.
Line Markings
Line markings shall be laid out and applied in accordance with the chosen governing
rules. A Running Track Stencils Kit is available and can be supplied with the coating materials
Please contact us if you have any questions about the resurfacing process that have not been
answered by the above application guidelines.
About Us | Products
| Do-It-Yourself |
Order | Contact | Home
